Features

Power cable with barrel connector for use with the 2GIG Edge security panel and remote keypad. Works with the in-the-box power supply.

3 meter 18 awg cable

DC+ & DC- spade connectors for easy connection to screw terminals on the 2GIG EDGE power supply.

Barrel connector compatible with the 2GIG Edge panel and Remote Keypad

• The Go Control Desktop Kit Case is an accessory for use with the 2GIG Go Control Panel.
• It quickly installs to allow users to place it on a flat surface rather than mounting it on a wall and provides them with two different viewing angles.
• Side bumper pads along the perimeter of the sleek Desktop Kit prevent it from sliding while also protecting the Go Control Panel from the surface and protect the surface from the panel.
• White Plastic Mount ONLY

• Model: SW-140170A
• Input: 100-240V-50/60Hz, 0.68A Max
• Output: 14.0V - 1700mA
• Efficiency Level: IV
• AND MORE!

FireFighter Smoke & CO Detector Listener-Transmitter

• Compatible with 345 Mhz wireless protocol
• Does not impact UL or Fire Marshall approval of existing smoke detectors
• Unique algorithm monitors alarm activity from existing UL smoke detectors
• Provides system notification of alarm from existing UL smoke alarms
• Listens for distinct UL required smoke alarm tone patterns, temporal 3
• 4-year battery life with CR123A battery
• Detection max mounting distance is 6 in.
• Operating Temp: 32°F (0°C) to 120°F (49°C)
• Operating Humidity: 5-95% noncondensing
• Dimensions (WxHxD) 1.6×2.9×0.0 in
• 2-year warranty
• FCC and IC approved

• This is an Extra battery pack for the 2GIG Go!Control® Panel to extend battery life or to use as a replacement battery.

• Golden Power
• Optional extra capacity battery
• Replaces standard internal Control Panel battery
• Required for UL985 fire warning system listing

To replace the battery in a 2GIG EDGE:

If desired, put the system in test mode with the monitoring station before proceeding

1. Disarm the panel.
2. Power off the panel.
3. Remove AC power from the panel.
4. Disconnect the panel from the mounting plate.
5. Disconnect the old battery from the PCB battery connector.
6. Ensure the backup battery is properly seated in the 2GIG EDGE chassis. The battery’s label should be facing up and the battery’s connector wire should be on the left with the wire running in the empty space between the battery compartment.
7. Insert the wired battery pin into the PCB battery connector.
8. Reconnect the panel to the mounting plate.
9. Restore AC power.

• Repeats 2GIG and Honeywell signals on 345MHz frequency
• 24-hour backup battery included
• Repeat indicator in the signal eliminates “repeated signal storm”
• Optional zone programming to supervise Tamper, AC Loss, and Low Battery