To replace the battery in a 2GIG EDGE:

If desired, put the system in test mode with the monitoring station before proceeding

1. Disarm the panel.
2. Power off the panel.
3. Remove AC power from the panel.
4. Disconnect the panel from the mounting plate.
5. Disconnect the old battery from the PCB battery connector.
6. Ensure the backup battery is properly seated in the 2GIG EDGE chassis. The battery’s label should be facing up and the battery’s connector wire should be on the left with the wire running in the empty space between the battery compartment.
7. Insert the wired battery pin into the PCB battery connector.
8. Reconnect the panel to the mounting plate.
9. Restore AC power.