• AL300ULM multi-output access control power supply/charger is specifically designed for use with access control systems and accessories.
• This unit converts a 115VAC / 60Hz input into five (5) individually protected Class 2 Rated power limited 12VDC or 24VDC outputs.
• Each output will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc.
• These outputs will operate in both Fail-Safe and Fail-Secure modes.
• Controlled trigger input is achieved through normally open (N.O.) or normally closed (N.C.) supervised input or the polarity reversal from an FACP (Fire Alarm Control Panel).
• A form "C" dry output relay enables HVAC Shutdown, Elevator Recall or may be used to trigger auxiliary devices.

Input:

• Input 115VAC / 60Hz, 3.5A.
• Input fuse rated @ 3.5A/250V.
• Fire Alarm Panel or Access Control System trigger inputs. N.O. or N.C.supervised trigger input and polarity reversal trigger input.

Output:

• 12VDC or 24VDC selectable outputs.
• 2.5A supply current.
• Five (5) (auto-resettable) PTC protected outputs, rated @ 2A.
• Output relay energizes when unit is triggered (form "C" contact rated 1A @ 28VDC).
• Filtered and electronically regulated output.
• Short circuit and thermal overload protection.

Battery Backup:

• Built-in charger for sealed lead acid or gel type batteries.
• Automatic switch over to stand-by battery when AC fails.

Supervision:

• AC fail supervision (form "C" contacts).
• Notification trigger is selectable for 30 seconds (factory set) or 6 hours.
• Low battery supervision (form "C" contacts).
• Battery presence supervision (form "C" contacts).
• Power fail supervision relay (form "C" contacts).

Visual Indicators:

• AC input and DC output LED indicators (power supply board).
• Red LEDs indicate condition of power outputs (multi-output board).
• Power & input trigger LEDs (multi-output board).

Temperature:

• Operating: 0° C to 49° C ( 32° F to 120° F ).
• Storage: - 20° C to 70° C ( -4° F to 158° F ).
• Relative Humidity 85% +/- 5%.

BTU/Hr (approx.):

• 12VDC: 15 BTU/Hr.
• 24VDC: 31 BTU/Hr.
• System AC input VA requirement: 166.75VA.