• NEW 2GIG Bypass Door/Window Sensor (2GIG-DW40-345)
• This micro-sized door/window contact gives you the ability to set a temporary bypass on a zone at the push of a button, rather requiring you to disarm and then re-arm the security system.
• After pressing and holding the integrated bypass button the sensor will remain bypassed until the contact closes again.
• This features works with any version of the 2GIG GC2 Panel.
• For GC2 Panels running firmware version 1.14, bypass events are also logged in the System History.

• Bypass locally with integrated button
• Bypass events logged in System History (requires firmware version 1.14)
• Low-profile micro contact (1.5 x 1.0 x 0.4 in)
• 345 MHz frequency

Specifications:

• Wireless Signal Range: 275 ft (80 m) open-air with Wireless Control Panel
• Code Outputs: Alarm; Alarm Restore; Supervisory; Low Battery; Tamper; Tamper Restore; Local Bypass Enabled*; Local Bypass Disabled*
• Transmitter Frequency: 345 MHz (crystal controlled)
• Supervisory Interval: 70 minutes
• Bypass State LED: Red LED
• Button: Local Bypass Button • Magnet: 5/8” max. gap
• Sensor Dimensions (D x H): 1.5 x 1.0 x 0.4 in (3.7 x 2.5 x 0.8 cm)
• Weight (including battery and magnet): 0.6 oz (15 g)
• Housing Material: ABS Plastic
• Color: White
• Operating Temperature: 32° - 120° F (0° - 49° C)
• Humidity: 5-95% Non-Condensing
• Compatibility: 2GIG Receivers
• Battery (included): CR2032 battery or equivalent
• Certification: FCC, IC
• Code Output messages for these bypass events are logged in the System History on GC2 Panels running firmware version 1.14 or later

System Requirements:

• GC2 Security Panel
• Firmware Version 1.14 (for logging bypass events in the System History)